Starter died right away the same week I got the car, all the busing were shot, suspension very weak, clutch was slipping, engine was burning oil, but not a lot.
My friend and I rebuilt the motor, shaved engine head, thin head gasket (copper), iridium spark plugs, MSD 8.5 mm wires, K&N cold air intake, Tokico struts, Eibach 1.5 inch lowering springs, poly bushings, 2.5 inch exhaust, DTM muffler, DCsports header 4 into 1 piece dual friction clutch.
Overall, everything that I did to the car cost a lot of money, but it's worth the ride. The engine has so much power, for a 4 cylinder it's unreal.
Where in the world did you get poly bushings?
alfarod@altavista.com.
I just purchased a 1990 Honda Prelude on 7/01/03 with slightly over 102K. The car runs like a dream. Need to know where to go to get performance parts, and I also need a rear tail light. From what I have seen parts look hard to find, and expensive. Any help would be greatly appreciated. bmorgan@tampabay.rr.com.
To anyone who reads this and can help me out. I am purchasing a 1990 Prelude Si this week. I'm curious as to what the stats were for it straight from the manufacturer, and I'm looking for custom and performance parts. If anyone could help me out at all I would appreciate it. My email address.. dudekd05@ecc.edu.
I found polly bushings at jcwhitney.com.
I need to know where I can find aftermarket parts for my 1991 Honda Prelude.
Thanks Joe
scort994@yahoomail.com.
If you still care (this review is 8 years old) where can I get a DCSports header for my B21?
Note: A Comments RSS Feed is available. New comments appear in the Members Area before the main site