My Blazer will not start. I have replaced: PCM, Camshaft position sensor, crank sensor, ignition module, distributor cap, rotor, plugs, plug wires, fuel pump, fuel filter, injectors, etc.
Car will still not start. Will run if fuel is poured directly into the intake for a moment. Fuel pressure is about 60psi. Injectors are getting power. Have hooked up to OBDII monitor; no codes. All sensors are receiving signal. ANY HELP very much appreciated!!
This has been an excellent vehicle and I have had only minor problems in the past, but this has stumped not only me, but every mechanic in town! I would buy another GM vehicle if I could fix this.
Check your fuel flow. You may have a static 60 psi charge.
Then no flow after that fuel in the fuel line has emptied out of the line.
Note: A Comments RSS Feed 
is available. New comments appear in the Members Area before the main site