1991 Nissan 200SX S13 1.8 turbo

Summary:

Bargain of the century paid £150 for it at auction I took a chance on it and its been fine

Faults:

When I purchased it from the auction it had a sticky offside brake caliper, but was soon rectified by myself.

General Comments:

Well performance is very good it is not modified in anyway, but is good for 140mph (Private test track)

Would you buy another car from this manufacturer? No

Review Date: 1st July, 2004

1991 Nissan 200SX 1.8 turbo

Summary:

Great fun, but consider saving up for a series 14 instead

Faults:

For the previous owner, the turbo bearings went due to a block in the original, u-bended, turbo oil-feed pipe.

Big-end bearings subsequently went due to age and turbo bearing particles in oil.

For me...

The new turbo smoked and produced excessive lag for about a year before I replaced it.

The engine developed a rattle which turned out to be big-end bearings again.

The engine was replaced with a lower mileage Japanese engine. This engine also rattles, probably due to big-ends, hence car is currently off the road.

Clutch slave cylinder has burst, possibly contributing to the destruction of a new clutch within 40 miles.

Bodywork is corroding, although easily treatable. Rear chassis sub-frame will eventually need replacing due to rust.

4 Hydraulic tappets broken.

Drivers seat snapped internally - welding required.

When I bought this car, I hadn't even changed a tyre before. I can now remove and rebuild 200sx engines - the only cost-effective way to keep this car going.

General Comments:

Deceptively cheap. To keep a 12-year 200sx on the road for long will probably cost more than the initial outlay for the car.

Design flaw in the engine bearings causes frequent engine failure around 90,000 miles. Engine removal with a crankshaft regrind and new bearings will most likely be required, costing about £200 for parts. Add another £600 for a garage to do this procedure for you.

Modified/uprated engines are much more prone to failure.

Immense fun to drive, almost (but not) outweighing the time and money involved in keeping the car going. Engine roars and turbo-boost is too addictive. One of the best cars to go sideways in.

Turbo lag means the car will seem sluggish to most drivers up to 3500 rpm. This can be avoided with clutch-straining, high-rpm racing starts.

Dangerous in wet/icy conditions. Avoid using the turbo on roundabouts, never jerk the steering wheel round corners. Pre-'92 models have no ABS so locking the wheels in the wet is not difficult.

When inspecting, rev the engine to 2500 rpm and listen for knocking, rattling or thumping when holding or releasing the throttle. If this is OK, listen at idle particularly once the car is warmed up. Resonance 'rasping' and fuel-injector ticking are O.K., but any rattles - WALK AWAY.

Also have a thorough look underneath the car for rust - check the chassis, sills, jack points (on sills), wheel arches and underneath the rear spoiler.

Blue smoke indicates turbo failure (most likely), valve oil seal failure or piston ring failure.

Fuel economy passable - expect no more than 30mpg on long journeys and near 20 around town (make sure timing, thermostat, Fuel/Air and idling speed are set correctly or it will be worse)

Nothing can guarantee a car will survive long after purchase. Service history helps, but how do you know if the car hasn't been thrashed every day of its life? You may find a great example, most often you will not. Do NOT buy the first one you see. Good luck hunting.

Would you buy another car from this manufacturer? Yes

Review Date: 17th November, 2003

19th Dec 2003, 20:09

Some pre 92` cars do have ABS. Mine has. 91 was changeover period, cars at this age may/may not have bigger disks (280mm instead of 257) Limited slip diff, ABS, different seats, revised front bumper.

1991 Nissan 200SX 1.8 16v turbo

Summary:

Don't get a Lemon

Faults:

Radiator was found to be blocked the day I took delivery.

1st Turbo failed after 6 months of ownership. Dealer promised me it was a new one when I bought it.

2nd Turbo (modified Hi-Flow) failed after one month.

Engine had to have the breather system modified. As it would always have a touch of blue smoke from the exhaust.

Automatic box wouldn't change from 1st to 2nd gear when cold, this started happening after 85,000 miles. Drained the fluid, which came out black. Needed a new auto-box.

Have two water leaks from rubber hoses deep inside the engine bay. Each time the garage had to take the inlet manifold off.

Big rust problem underneath rear spoiler. Had to cut the metal back and fill. Then re-sprayed. Look good after.

Milo-meter would stick sometimes, had to flick the tachometer to make it work.

Drivers window feel into door, due to faulty windows clips.

General Comments:

Car was a dream to drive.

Very comfortable.

Even tho it was very unreliable, the engine was always smooth and willing.

My 200SX had an hybrid Turbo, Boost upgrade to 15PSI, Bump Valve, ECU chip upgrade and Janspeed Exhaust. about 220bhp.

Stupid kickdown on automatic box didn't match the turbo engine. If you floored the throttle, the auto box would drop a gear then you would hit boost, and the engine revs would end up in RED line.

Insurance wasn't too bad for me. But fuel costs were high. More so after engine mods.

Had a good relationship with Norris Designs who did all the repairs and servicing.

Think my car was a lemon, should have bought something a bit more main-stream. But liked my car while I had it.

Would you buy another car from this manufacturer? No

Review Date: 16th November, 2003